Sphenix-calibration-l mailing list

[Ross Corliss <rcorliss AT mit.edu>]

Hi Takao,

Thanks for the comments. 

slide 5: 'p and z' refer to the phi and z coordinates where the slice through r was taken.  I've patched a small "at φ=3.054, z=53.629 " over that.

slide 14: I've added explicit mention of the ideal-field distortion magnitudes.

-Ross

On Sep 18, 2020, at 10:09 AM, Takao Sakaguchi via sPHENIX-calibration-l <sphenix-calibration-l AT lists.bnl.gov> wrote:

Dear Ross,

 Thanks for posting the very nice slides. Just a few comments
below:

- slide 5: In the delta-r plow, there are parameters of p and z.
They show up frequently with the similar plots in later slides.
Maybe adding their definition will help?

- slide 14: Maybe writing again the distortion numbers from
the slide 11 will help audience evaluate the numbers here?

 Again, the slides are very nice already.

Takao

On 9/18/20 2:36 AM, Ross Corliss via sPHENIX-calibration-l wrote:

Hi Hugo,

Your slides look good.  I believe Henry's code includes the z distortions now (and they are less contentious than the r and phi distortions) -- in your conclusion slide you say that z distortions are still missing, but I suspect that means from the old maps, not the 'latest and greatest'?  


A draft for my slides is similarly attached, and comments are similarly welcome.

_______________________________________________
sPHENIX-calibration-l mailing list
sPHENIX-calibration-l AT lists.bnl.gov
https://lists.bnl.gov/mailman/listinfo/sphenix-calibration-l

_______________________________________________
sPHENIX-calibration-l mailing list
sPHENIX-calibration-l AT lists.bnl.gov
https://lists.bnl.gov/mailman/listinfo/sphenix-calibration-l