Skip to Content.
Sympa Menu

sphenix-hcal-l - [Sphenix-hcal-l] Fwd: Чертежи на прессованные детали

sphenix-hcal-l AT lists.bnl.gov

Subject: sPHENIX HCal discussion

List archive

Chronological Thread  
  • From: Edward Kistenev <kistenev AT bnl.gov>
  • To: John Lajoie <lajoie AT iastate.edu>
  • Cc: sphenix-hcal-l AT lists.bnl.gov
  • Subject: [Sphenix-hcal-l] Fwd: Чертежи на прессованные детали
  • Date: Tue, 27 Nov 2018 11:11:45 -0500

John, attached pictures may help to understand the status. Link is to the movies are to  show this whole dance runs. We have blockers and holders which are molded  to Richard’s design and UNIPLAST we’ll do its best to get them to BNL in quantities.  If you have an inbound FedEx account it may help with speeding the shipment. Small problem - customs. Probably by tomorrow we’ll have component drawings updated (to the last few microns) to the actual dimensions as coming of injection mold. Most important - everything is tested for insertion/extraction forces and against multiple actual SiPM boards with installed SiPM’s and attached cables. 

I am not sure if anything what Rich has is an actual unit. Rich - please check the width of extension - if it is 5.8(?)  then it is the right one otherwise it is the old one.


From: Людмила Небосенко <uniplast AT bk.ru>
Subject: Re: Чертежи на прессованные детали
Date: November 27, 2018 at 10:52:45 AM EST
To: Edouard Kistenev <kistenev AT bnl.gov>
Reply-To: Людмила Небосенко <uniplast AT bk.ru>



К этому письму приложены ссылки на следующие файлы: 

1. 20181127_172227.mp4 (30.3 Мб)
2. 20181127_173423.mp4 (19.7 Мб)

Ссылка для скачивания файлов: https://cloud.mail.ru/stock/MhTgrp5TLsrH5PoizfQK7uCr 

Файлы будут храниться до 27.12.2018 



  • [Sphenix-hcal-l] Fwd: Чертежи на прессованные детали, Edward Kistenev, 11/27/2018

Archive powered by MHonArc 2.6.24.

Top of Page