sPHENIX EMCal discussion

["Huang, Jin" <jhuang AT bnl.gov>]

Hello everyone

Please find a draft poster for " Design and test-beam performance of the 
sPHENIX calorimeter system " as on the following link:
https://www.phenix.bnl.gov/phenix/WWW/publish/jinhuang/Meetings/2017.02.06%20QM/sPhenix_QM17poster_calo.pdf
 

Comments and suggestions the next three days will be appreciated. I will 
continuing refining the poster in meanwhile and printout later in the coming 
week. 

Cheers,

Jin

______________________________

Jin HUANG, Ph. D.

Associate Physicist
Brookhaven National Laboratory
Physics Department, Bldg 510 C
Upton, NY 11973-5000

Office: 631-344-5898
Cell:   757-604-9946
______________________________


> -----Original Message-----
> From: Huang, Jin
> Sent: Tuesday, September 27, 2016 2:10 PM
> To: sphenix-electronics-l AT lists.bnl.gov; sphenix-emcal-l AT lists.bnl.gov;
> sphenix-hcal-l AT lists.bnl.gov
> Cc: 'Megan Connors' <meganEconnors AT gmail.com>; Mannel, Eric
> <mannel AT bnl.gov>
> Subject: RE: [Sphenix-emcal-l] [Sphenix-hcal-l] QM abstracts
> 
> Hello Everyone,
> 
> Thanks for the suggestions from John and Eric. I have prepared a calorimeter
> talk abstract as following. I also hope to coordinate with collaborators
> regarding adjustments and submission.
> ______________________________
> 
> Design and test-beam performance of the sPHENIX calorimeter system
> 
> The sPHENIX Collaboration at RHIC is planning a major upgrade to the
> PHENIX experiment by constructing an entirely new spectrometer based on
> the former BaBar solenoid magnet that will enable a comprehensive study of
> jets and heavy quarkonia in relativistic heavy ion collisions. The sPHENIX
> spectrometer will include one tungsten-scintillating fiber electromagnetic
> calorimeter surrounded by two layers of steel-scintillator sampling hadronic
> calorimeters, which will cover an acceptance of ±1.1 units in pseudorapidity
> and full azimuth. The first prototype of this calorimeter system has been
> tested at Fermilab in April of 2016, while the second prototype is taking 
> data
> in early 2017. Design considerations, test beam results and performance
> projection for the sPHENIX calorimeter system will be presented in this 
> talk.
> ______________________________
> 
> 
> Best regards
> 
> Jin
> 
> ______________________________
> 
> Jin HUANG
> 
> Brookhaven National Laboratory
> Physics Department, Bldg 510 C
> Upton, NY 11973-5000
> 
> Office: 631-344-5898
> Cell:   757-604-9946
> ______________________________
> 
> From: sphenix-emcal-l-bounces AT lists.bnl.gov [mailto:sphenix-emcal-l-
> bounces AT lists.bnl.gov] On Behalf Of Megan Connors
> Sent: Monday, September 26, 2016 10:31 PM
> To: Mannel, Eric <mannel AT bnl.gov>
> Cc: sphenix-electronics-l AT lists.bnl.gov; sphenix-emcal-l AT lists.bnl.gov;
> sphenix-hcal-l AT lists.bnl.gov
> Subject: Re: [Sphenix-emcal-l] [Sphenix-hcal-l] QM abstracts
> 
> Dear all,
> I would also like to submit an abstract on the HCal/testbeam. A drafted
> abstract is below. I hope to coordinate the details with others. Best 
> Regards,
> -Megan
> 
> A Prototype of the sPHENIX Hadronic Calorimeter The proposed sPHENIX
> experiment is designed to reconstruct jets in heavy-ion collisions at RHIC. 
> A
> crucial component to reconstructing the energy of jets is the sPHENIX
> calorimeter system which includes electromagnetic and hadronic
> calorimeters. The hadronic calorimeter (HCal) is a sampling calorimeter with
> alternating layers of steel absorber and scintillating tiles.  There is an 
> inner
> and larger outer HCal, located inside and outside of the solenoid detector.
> Prototypes of the EMCal, inner HCal and outer HCal were tested at the
> Fermilab Test Beam Facility. Measurements of the energy resolution satisfy
> the requirements of the proposed sPHENIX physics program and are
> consistent with GEANT4 simulations. In addition to results of the test beam,
> the tile testing and calibration procedure for the HCal will be discussed.
> 
> 
> On Mon, Sep 26, 2016 at 6:04 PM, eric mannel <mannel AT bnl.gov> wrote:
> John-
> I agree with your assessment of the calorimeter talks at QM.
> In terms of electronics, I would suggest this for the electronics:
> 1. Front end (SiPMs/Analog section, including temperature and leakage
> current compensation and slow control (Sean/Eric/Steve)
> 2. Digitizers/calorimeter trigger (Sara/Chi)
> 3. DAQ including tracking (Martin)
> For the test beam results, I am wondering if we should not push for a talk
> along with a posters focused on the EMCal and HCal analysis separately; Jin
> for the talk and Virginia and Abhishek respectively for posters.
> Ron and Vera would be natural for the HCal and EMCal detector construction
> posters respectively.
> Eric
> On 9/26/16 4:26 PM, John Haggerty wrote:
> Hello,
> 
> I think that we should cover all parts of the sPHENIX proposal in the
> Quark Matter poster abstracts if possible; Tom had a nice organization
> of the tracking-related abstracts, but the calorimeters have some holes
> and inconsistencies.
> 
> I think the abstracts we want are these:
> 
> EMCAL detector
> HCAL detector (including tile testing?)
> Calorimeter electronics and SiPM's
> Digitizer and calorimeter trigger
> Beam test results
> 
> Data acquisition and triggering (including TPC, INTT, and MAPS)
> Minimum bias trigger device?
> 
> Magnet? (low and high field testing, mapping, etc)?
> 
> Items with question marks are ones that I consider optional.
> 
> 
> 
> --
> Eric J. Mannel, Ph.D.
> PHENIX Group
> Physics Dept.
> Brookhaven National Laboratory
> 631/344-7626 (Office)
> 914/659-3235 (Cell)
> 
> _______________________________________________
> Sphenix-hcal-l mailing list
> Sphenix-hcal-l AT lists.bnl.gov
> https://lists.bnl.gov/mailman/listinfo/sphenix-hcal-l