sPHENIX discussion of the superconducting solenoid

[Kin Yip <kinyip AT bnl.gov>]

Hi,

Thanks a lot !   I hope Sonny can do his electrical/hypot test soon ... and Paul Giannotti/Frank Toldo and Richard Meier can hook up the signals ...

Kin

On 10/30/2017 02:25 PM, Ceruti, Raymond B wrote:

Hi All,

 

       Helium lines leak check was good to go.  We can continue with all electrical, temp sensors, and strain gauge hookups, hipot should probably be next however.

 

Regards,

Ray

 

 

 

 

 

From: Kin Yip [mailto:kinyip AT bnl.gov]
Sent: Monday, October 30, 2017 11:59 AM
To: Ceruti, Raymond B; Gill, Stephen M
Cc: Meier, Richard; Tallerico, Thomas N
Subject: Re: Leak checking

 

Hi Ray,

Thanks !  Please let us know when you finish finally.

Kin

On 10/30/2017 11:56 AM, Ceruti, Raymond B wrote:

Hi Gents,

 

      I met Steve’s vacuum techs this morning and all is good so far.  We will meet once more after the system pumps down a little more during lunch and go over the joints one more time to be sure.

 

Thanks to all,

Ray

 

From: Gill, Stephen M
Sent: Monday, October 30, 2017 10:10 AM
To: Yip, Kin; Ceruti, Raymond B
Cc: Meier, Richard; Tallerico, Thomas N
Subject: RE: Leak checking

 

We’ll be there after coffee, acout 10:35-ish

 

From: Gill, Stephen M
Sent: Monday, October 30, 2017 10:06 AM
To: Yip, Kin; Ceruti, Raymond B
Cc: Meier, Richard; Tallerico, Thomas N
Subject: RE: Leak checking

 

I hope so too

 

From: Yip, Kin
Sent: Monday, October 30, 2017 9:45 AM
To: Ceruti, Raymond B; Gill, Stephen M
Cc: Meier, Richard; Tallerico, Thomas N
Subject: Leak checking

 

Hi,

 

I just saw a few vacuum group people walking up to the platform with the leak check equipment ... I hope they know where to check ?

 

Sent from my Verizon LG Smartphone