E-rhic-ir-l mailing list

["Montag, Christoph" <montagc AT bnl.gov>]

I don't have anything to show either. I cut my detector beampipe into 9cm 
long segments (that's 100 segments, hence the 9cm) for radiation simulations 
with DESYNC. Only in the first two segments after the 4.5m mask do I see 
radiation levels above a few urad/h. I could probably get rid of that by 
making the beampipe aperture a little larger. Right now it's the same as the 
mask.

Christoph 
________________________________________
From: E-rhic-ir-l [e-rhic-ir-l-bounces AT lists.bnl.gov] on behalf of Palmer, 
Robert [palmer AT bnl.gov]
Sent: Friday, May 12, 2017 2:06 PM
To: Christie, William; E-rhic-ir-l AT lists.bnl.gov
Subject: Re: [E-rhic-ir-l] Meeting today at 3 pm?

I do not have anything on the IR, but I would like to share slide 12 from our 
IPAC17 parameters poster. Vadim would be interested, I think.

Bob

-----Original Message-----
From: E-rhic-ir-l [mailto:e-rhic-ir-l-bounces AT lists.bnl.gov] On Behalf Of 
Bill Christie
Sent: Friday, May 12, 2017 12:45 PM
To: E-rhic-ir-l AT lists.bnl.gov
Subject: [E-rhic-ir-l] Meeting today at 3 pm?

Dear All,
     I just noticed that no meeting notice went out for our bi-weekly eRHIC 
IR meeting for today. As a reminder, Elke and Alexander are not going to be 
able to attend today, so the idea we discussed was to have a brief mtg to 
start writing down some of the requirements/specification for the beam pipe 
in the IR region.
     I propose that we hold the meeting at 3 pm today for those who are 
available. Perhaps it will be a short mtg.
     Greetings,
         Bill
_______________________________________________
E-rhic-ir-l mailing list
E-rhic-ir-l AT lists.bnl.gov
https://lists.bnl.gov/mailman/listinfo/e-rhic-ir-l