sPHENIX discussion of the superconducting solenoid

[John Haggerty <haggerty AT bnl.gov>]

This was apparently not disseminated, but the cryostat has been surveyed 
to verify its dimensions.

-------- Forwarded Message --------
Subject:        FW: CRYO MAGNET
Date:   Wed, 01 Apr 2015 10:40:18 -0400
From:   dlynch AT bnl.gov <dlynch AT bnl.gov>
To:     Richard Ruggiero <ruggiero AT bnl.gov>
CC:     Mills, James A <mills AT bnl.gov>, John Haggerty <haggerty AT bnl.gov>,
Edward O'Brien <eobrien AT bnl.gov>, Carter Biggs <biggs AT bnl.gov>



Hi Rich,

This is the report from the survey group on the Magnet cryostat
dimensions. We are probably most interested in the minimum inner
diameter (radius), the maximum outer diameter (radius) and the minimum
length which are as follows:

Cryostat Minimum Inner Diameter (Radius) :  2830.5 mm (1415.2 mm)

Cryostat Maximum Outer Diameter (Radius) :  3542.1mm (1771.0 mm)

Cryostat maximum length, mm : 3848.9 mm

  You probably also need dimensions to locate the mounting pads and
clearance dimensions for the tensioning rod extensions. I will email
Matt Ilardo for that info.

-Don

From: "Ilardo, Matthew" <milardo AT bnl.gov <mailto:milardo AT bnl.gov>>
Date: Wednesday, April 1, 2015 at 10:11 AM
To: Don Lynch <dlynch AT bnl.gov <mailto:dlynch AT bnl.gov>>, "Phillips, David
B" <phillips AT bnl.gov <mailto:phillips AT bnl.gov>>
Cc: "Hock, Jonathan" <jhock AT bnl.gov <mailto:jhock AT bnl.gov>>
Subject: RE: CRYO MAGNET

Here is a report on the Dimensions, let me know if you have any
questions. Thank you.

*From:*Lynch, Don
*Sent:* Friday, March 27, 2015 8:10 PM
*To:* Phillips, David B
*Cc:* Ilardo, Matthew; Hock, Jonathan
*Subject:* Re: CRYO MAGNET

We are most interested with the Cryostat ID and OD and length, as
measured at different locations, with the maximum, and minimum
measurements for each.

Don

Sent from my iPad


On Mar 27, 2015, at 1:00 PM, Phillips, David B <phillips AT bnl.gov
<mailto:phillips AT bnl.gov>> wrote:

    I think the whole cryostat, so we know we have an accurate model.

    The 6 pads at each end are important.

    The “Dog House” and all the support rods are also important.

    Don & Jon, what do you think?

    *From:*Ilardo, Matthew
    *Sent:* Friday, March 27, 2015 11:21 AM
    *To:* Phillips, David B
    *Subject:* CRYO MAGNET

    Dave,

                     What info are they looking for on the Phoenix Cryo?
    Thanks.

    <image001.jpg>


--
John Haggerty
email: haggerty AT bnl.gov
cell: 631 741 3358

Attachment: image001.jpg
Description: JPEG image

Attachment: PHENIX Cryo Dimensions.pdf
Description: Adobe PDF document