Star-fst-l mailing list

[董家宁 <jndong AT sdu.edu.cn>]

Hi Steve,
   
  Do you mean the metal cable soldered to the T-Board? If yes, usually the 
stripping length is about 1 - 2 mm. Since the T-Board thickness is 1.2 mm, I 
think 2 mm should be enough, and redundant part can be cut off after fixed.
  Let me know if you have any concerns.

Best,
Jianing




> -----Original Messages-----
> From: "Valentino, Stephen" <svalentino AT bnl.gov>
> Sent Time: 2019-03-18 23:21:34 (Monday)
> To: "star-fst-l AT lists.bnl.gov" <star-fst-l AT lists.bnl.gov>
> Cc: 
> Subject: [Star-fst-l] Inner Cable Test Prototype Jacket Strip-Back Distance 
> at T-Board
> 
> Hi Li,
> 
> We are building a sample of the prototype inner cable for testing and there 
> is one last detail we need to know.
> 
> On the T-Board end, how much of the cable outer jacket should be stripped 
> back?  
> I think this will depend on the plan for securing the cable and also the 
> layout of the vias on the T-Board.  
> 
> We can always modify it to fit later, but it would be good to have a value 
> for the vendor to use while building the 10 prototype test cables.
> 
> Regards,
> Steve Valentino
> 631-344-4644
> 
> _______________________________________________
> Star-fst-l mailing list
> Star-fst-l AT lists.bnl.gov
> https://lists.bnl.gov/mailman/listinfo/star-fst-l