Star-fst-l mailing list

[Gerard Visser <gvisser AT indiana.edu>]

hi Zhenyu,
	Will the V2 T boards ever be used with a sensor? If not, do we really want to 
make 6? I'm not sure of the point of making so many (with cables and Nicomatic 
connectors and all).

        Gerard


On 5/29/2019 9:49 PM, Zhenyu Ye wrote:
> Thanks for the nice work, Mike/Steve.
>
> If I remember correctly, you have six V2 T_boards. About the direction of the 
> cable for these T_boards,  please make two more that is the same as the one 
> you did, and the other three with a right angle turn but from the other 
> direction than the one you did.
>
> We will also need a few (six) V2.1 T_boards assembled once SDU get the new 
> boards. How many spare cables will you have after the above V2 T_board 
> assembly? If the number is less than 6, we need to save them for V2.1 
> T_boards.
>
> Best,
> Zhenyu
>
>
>
> > On May 29, 2019, at 9:56 AM, Valentino, Stephen <svalentino AT bnl.gov> wrote:
> >
> > Hi Zhenyu and all,
> >
> > Mike C. test soldered an Inner cable to the V2 T-Board.  The wiring will fit 
> > snuggly in 5.12mm so a 6.2mm height restriction should be fine.
> >
> > See details at the link below.
> > https://drupal.star.bnl.gov/STAR/blog/steve/test-soldering-fst-inner-cable-t-board-29may19
> >       
> >
> > In the pictures, you can see that the cable makes a right angle turn then 
> > enters the T-Board on the short side nearest the via holes the cable is 
> > soldered to.  When we solder up the rest of the V2 T_boards we have, from 
> > which direction should the cable approach the T-Board?  Does it even matter 
> > for the tests?
> >
> > Regards,
> > Steve Valentino