sphenix-magnet-l AT lists.bnl.gov

Subject: sPHENIX discussion of the superconducting solenoid

List archive

[Sphenix-magnet-l] From Pasquale: Turns of Babar Coil (after I showed him the "PS Manual" page that Bob has indicated)

From: "Yip, Kin" <kinyip AT bnl.gov>
To: "sphenix-magnet-l AT lists.bnl.gov" <sphenix-magnet-l AT lists.bnl.gov>
Subject: [Sphenix-magnet-l] From Pasquale: Turns of Babar Coil (after I showed him the "PS Manual" page that Bob has indicated)
Date: Wed, 15 Apr 2015 11:58:32 +0000

------ Original message------

From: fabbric

Date: Wed, Apr 15, 2015 07:36

To: Yip, Kin;

Subject:Turns of Babar Coil

Kin,

I was back to my office before I could expect and
I looked at the data reported during the construction.
Indeed the turns lay-out was changed wrt the design.
According the Quality Control Sheath the external layer is done with
188 (thin)+159 (tick) + 189 (thin) =536 turns

The inner layer:
184 (thin)+164 (tick) + 183 (thin) =531 turns

So, in the end, the report in your hand
has the correct information.

I also found some photos of an insulated internal
splice taken during the winding and a couple of photos
of the leads. In the latter photos you can see the Rutherford cable
extracted from
the stabiliser and subsequently embedded in the copper
leads through a soft soldering.
Please forward this information to Mike Anerella.

Best Regards

Pasquale

--
Dr. Pasquale Fabbricatore
INFN Sezione di Genova
via Dodecaneso 33, 16146 Genova Italy
Direct tel + 39 010 3536340
Laboratory + 39 010 3536437
Secret.fax + 39 010 313358
E-mail pasquale.fabbricatore AT ge.infn.it
WEB page http://www.ge.infn.it/~fabbric/

Attachment: Joint.jpg
Description: Joint.jpg

Attachment: Leads.jpg
Description: Leads.jpg

[Sphenix-magnet-l] From Pasquale: Turns of Babar Coil (after I showed him the "PS Manual" page that Bob has indicated), Yip, Kin, 04/15/2015