Star-fst-l mailing list

[videbaek <videbaek AT bnl.gov>]

Hi all,

The cooling test is performed seperately for the integration test as 
discussed a long time ago.
Te IST/FST cooling system is currently setup in the assembly building. 
The plan is after the integration test to bring the dark box to the 
assembly building on a chart at the cooling unit.
It will be connected to the cooling unit manifolds

Rahul/Bill will check if we have longer ~5 ft cooling tubes available 
for this.Will order if not available right now.
Xu make us aware that the one cooling connector is very close to the 
edge of the holding box.
  Hopefully the tubes ar flexible enough to connect.
The cooling tubes must be grounded as pointed out several times.Yi do 
you have the information on clips that are suitable?
The control of the wedge/module will be made via the (a) long grey cable 
+PPB and the MPOD crate + computer should be setup in the Assembly 
building. As the cabl is long there is lost of flexibility where to put 
this.
It should be possible to run this w/o needing connection to the local 
network.
Prithwich and Yu should confirm this with a lab test before setting up 
in the hall.
The local temp from the APV should be readout and recorded.

Rahul will like to complete the test in the next two weeks, so the 
cooling unit can be installed
on the North platform lower level before closseout.

best Flemming





--
Flemming Videbaek
senior scientist
videbaek @ bnl.gov
Brookhaven National Lab
Physics Department
Bldg 510D
Upton, NY 11973

phone: 631-344-4106
cell     :  631-681-1596